Locate the stud in the wall you are mounting to and mark the top hole.
Drill 11/64 pilot hole and insert the provided #14 wood screw, tightening
slightly. Using a level, mark the lower hole and drill pilot hole, insert the
last #14 screw and, with the unit level, tighten both screws.
Note: ICW supplies #14 wood screws, if installing into metal studs
you will need to use proper metal stud fasteners.
If your monitor is over 17” the mount may be more effective if mounted
upside down.
Wall Mount
Nylock
Large washer
Desk
Drill a 3/8 hole through the horizontal surface you intend
to mount to and push the 3/8 stud on the desk mount through
the hole. Slip the large mounting washer over the stud from
underneath and secure in place with the 3/8 nylock.
Screw stud into
deskmount.
Desk Mount
Pole Mount
Using the 1/4” hex key,
separate the two halves of
your pole mount as shown,
place around pole at the
desired height and reassemble.
Set screws
Using a 1/8” hex key, make sure the set screws
in the radius mount are pulled out enough that
the mount will easily slide down over the pole.
Then retighten set screws.
Pole
Radius Mount
2
