Page 1
ULTRA 180 & 182 ARM INSTALLATION - 6/29/20
Page 1 of 4
If Mounting to Ultra Wall Track
If Mounting to a Desk
• Drill a 3/8” hole through the horizontal
mounting surface.
• Screw stud into base of desk mount.
• Push the stud on the desk mount
through the hole.
• Slide the large mounting washer over
the stud from underneath.
• Add the 3/8 split-washer.
• Secure in place with the 3/8 nylock.
Screw stud into
desk mount
Desk
Desk
Washer
Nylock
ATTACH ULTRA DESK MOUNT
ATTACH SLIDER TO ULTRA TRACK
• Insert slider into
wall track.
• Replace the
small socket
head cap
screw and
plastic cover.
Adjust slider to desired height. Tighten slider using adjustment knob.
ADJUST SLIDER POSITION
STANDARD
INVERTED
Adjust slider to desired height. Tighten slider using adjustment knob.
ADJUST SLIDER POSITION
STANDARD
INVERTED
ICW recommends
wood or metal stud
mounting only.
MAXIMUM LOAD CAPACITY: 32 LBS. (14.5 KG)
ULTRA 180 & 182 ARM INSTALLATION
• Drill a 3/8" hole thorugh the
horizontal mounting surface.
• Screw stud into base of desk mount.
• Push the stud on the desk mount
through the hole.
• Slide the large mounting washer
over the stud from underneath.
• Secure in place with 3/8" nylock nut.
Desk Mount
Part Number
Stud
Length
Maximum
Desk Thickness
D0
3.50”
2.47”
D1
3.50”
1.87”
D3
5.50”
1.87”
D5
7.50”
1.87”
D7
10.50”
2.38”
Screw stud
into desk mount
• Insert slider into wall track.
• Replace the plastic cover
and small socket
head cap screw.
Adjust slider to desired height. Tighten slider using adjustment knob.
ADJUST SLIDER POSITION
STANDARD
INVERTED
Adjust slider to desired height. Tighten slider using adjustment knob.
ADJUST SLIDER POSITION
STANDARD
INVERTED
STANDARD
INVERTED
Desk
Desk
Washer
Nylock
• Remove small socket head cap screw in the top
center of the Wall Track. Remove plastic cover.
• Locate the wall stud and mark the top hole of the
Wall Track.
• Drill 11/64 pilot hole, insert #14 screw and tighten
slightly. Use a level, mark the lower holes, drill
pilot holes and then insert the #14 screws.
NOTE: #14 Wood screws are supplied with unit. If installing into
metal studs, you will need to replace these with proper metal
stud fasteners
MOUNT ULTRA TRACK TO WALL
MOUNT ULTRA TRACK TO WALL
• Remove small socket head cap screw in the top center of
the Wall Track. Remove plastic cover.
• Locate the wall stud and mark the top hole of the Wall Track.
• Drill 11/64 pilot hole, insert #14 screw and tighten slightly.
Use a level, mark the lower holes, drill pilot holes and then insert
the #14 screws.
NOTE: #14 wood screws are supplied with unit. If installing into metal
studs you will need to replace these with proper metal stud fasteners
or the provided snap togglers. All hardware used to secure track mount
must have a proper countersunk head.
