ULTRA 180 & 182 ARM INSTALLATION - rev 11/22/17
Page 2 of 4
If Mounting To A Wall
If Mounting to an MD Track
If Using EV65
Attach the
monitor mount
assembly to
the back of
your monitor,
using the
4mm screws
provided.
ATTACH VESA TO MONITOR
ULTRA, UL180 & UL182 ARM INSTALLATION
If Mounting To A Pole
•
Using the 1/4” hex key,
separate the two halves
of pole mount as shown.
•
Place around pole at
the desired height and
reassemble.
ATTACH POLE CLAMP TO POLE
Socket
cap screw
VESA
plate
•
Insert stubs on VESA plate
into holes in the Ergovision
joint assembly.
•
Insert provided 5/16 x 3/4
socket cap screws
in both sides
and tighten.
•
Use the handle
under mount to
loosen tilt friction and
adjust monitor tilt.
ATTACH VESA TO EV65 JOINT
ICW recommends wood or metal stud mounting only.
•
Locate the wall stud and mark
top hole for wall mount.
•
Drill 11/64” pilot hole. Insert #14
screw and tighten slightly.
•
Using a level, mark the lower
hole(s) and drill pilot hole(s).
•
Insert #14 screw(s) and, with the
unit level, tighten all screws.
NOTE: ICW supplies #14 wood screws. If
installing onto metal studs, you will need to
replace with proper metal stud fasteners.
MOUNT WALL PLATE TO WALL
W2
Use a level
to be sure
mount is
correctly
aligned.
W3
W2
W3
Use a level to be sure mount is correctly aligned.
•
Install track as per MD track installation.
•
Loosely attach track adapters
to wall ear (W2 or W3).
•
Slide wall ear with loosely attached
track adapters into MD track.
•
Once in desired position, tighten one
track adapter with 5/32 Allen wrench.
•
Check to ensure wall ear is level and
tighten remainder or track adapters.
MOUNT WALL PLATE TO MD TRACK
Attach the
monitor mount
assembly to
the back of
your monitor,
using the four
4mm screws
provided.
