ULTRA 180 & 182 ARM INSTALLATION - rev 11/22/17
ATTACH FLIP UP
•
Remove screws from
drop extension using
5/32” hex key.
•
Align holes in keyboard
tray with screw holes in
drop extension.
•
Attach keyboard tray using
the provided screws.
•
If keyboard will not remain in vertical
position, tighten two button head
screws underneath fl ip up connector.
Page 3 of 4
If Using EV710
ULTRA, UL180 & UL182 ARM INSTALLATION
If Attaching To Ultra Flip-Up
Ultra 180 & 182 Arm Cable Management
If Attaching To
Quick Disconnnect
ADJUST BALL VESA HEIGHT & TENSION
•
To adjust the height of
monitor, loosen slider
knob, position monitor
height on slider rails,
then tighten knob.
•
To adjust pivot tension,
gently and evenly
tighten or loosen the
four screws on the back
of the ball VESA.
Pivot tension
adjustment screws
Slider
knob
ATTACH QUICK DISCONNECT
•
Remove beauty cap
on Quick Disconnect
block.
•
Remove screw using
3/16” hex key.
•
Slide keyboard tray
into Quick Disconnect
block.
•
Replace screw and
tighten.
•
Replace beauty cap.
Beauty cap
Screw
RUN CABLES THROUGH ARM
•
Cover plate is spring loaded. Loosen cover plate screws
on side of arm just enough to fit cables through gap.
•
Run cables loosely between cover plate and arm.
Cables can be run on either or both sides of the arm.
•
Push cover plate against arm and
tighten screws, being careful
not to pinch cables.
STORE CABLE INSIDE COVER PLATE
Extra cable can be looped inside the cover plate to provide
a neater appearance and simplify cleaning.
•
Mount VESA
assembly to
slide rails.
•
Screw slider knob
through rails and
into VESA assembly.
•
Attach VESA to
monitor using four
4mm screws in the
hardware bag.
MOUNT VESA TO SLIDE RAILS, ATTACH MONITOR
•
Mount VESA
assembly to
slide rails.
•
Fasten slider knob
through rails and
into VESA assembly.
•
Attach VESA to
monitor using four
4mm screws in
the hardware bag.
•
Remove screws from
drop extension using
5/32” hex key.
•
Align holes in keyboard
tray with screw holes
in drop extension.
•
Attach keyboard tray
using the provided screws.
•
If keyboard will not remain in vertical
position, tighten the two button head
screws underneath flip-up connector
to adjust the flip-up’s tension.
ATTACH FLIP-UP TRAY
