Smart Channel Hopping - During operation, the ID2400TR constantly monitors the transmission for
interference. If interference is detected, the phone automatically scans for and hops to the next clear
channel. This hopping is instant and does not interrupt normal conversation.
Maximum Security
- The security code is changed every, selected from one of 2^24million different
codes making interception virtually impossible.
3 Level Power Output
- The ID2400TR constantly monitors the strength of the signal from the
TRANSIMITTER to the DOCKING STATION, selecting one of three transmission power levels for maximum
range and extended battery life.
INSTALLATION
HOW to Install the li-ion Battery
1. Remove the battery compartment cover of the transmitter by sliding it down.
2. Connect the battery plug along the slot into the transmitter’s battery connector.
3. Insert the Li-ion battery pack into the battery compartment by sliding it up.
NOTE : The Li-ion battery must be fully charged at least 4 hours before initial use.
Please refer to the “Charging the Battery (Full Charge)” section.
POWER CONNECTION
CAUTON
: You must use a 120Volt AC/9-12Volt DC adaptor that delivers
at least 300-500mA for charger.
The plug must correctly fit the machine’s DC 12V jack.
1. Plug the AC Adaptor into a standard AC outlet.
2. Plug the adaptor plug into the DC 12V jack on the rear of the docking station.
CHARGING THE BATTERY (FULL CHARGE)
1. Once the docking station has power connection, place the transmitter in its cradle on the docking
station.
2. Leave the transmitter on the cradle for at least 4 hours for a full charge.
NOTE
: The Li-ion battery is continuously charged when the transmitter is on the cradle of the docking
station.
PREPARING FOR INITIAL USE
1. setting the Battery on transmitter.
2. Ensure that the Li-ion battery is installed and fully charged before initial use.
3. Check line and power connections.
