ID Lock 202 Multi
Installation manual
9
2022-11-30
Configuration
Important
Make sure you an alternate entrance or someone on the inside when configuring your lock.
Alternatively, the door can always be left open while you test and you can "simulate" the door
closes by holding down the sensor latch (see figure 16 on the previous page).
Batteries
1.
Use 4 or 8 alkaline AA-batteries (LR06). Only use new batteries of
same type.
2.
Leave the door in an open and unlocked position when inserting the
batteries.
3.
Remove one of the batteries so that only 3 batteries are inserted and
test the emergency terminals on the outside by holding a 9V battery
against the terminals. Make sure the touch panel wakes up and lights
up.
4.
Remove the protective film from the touch panel (see figure 19).
F
igure 19
–
Remove the
protective film
Figure 18
–
9V battery
Figure 17
–
Batteries
