Assembly instructions for VR Series
ASSEMBLY INSTRUCTIONS
Selection of fastening material:
Material and corrosion resistance:
the choice of material for the fasteners is
dependent on the installation environment
and operating conditions (e.g. galvanised,
stainless steel, etc.), strength grade 4.8 - 8.8
Type of screw:
depends on the substructure (e.g. hexagon
screws, T-head screws, etc.); not included in
delivery
Fastening diameter:
depends on the Cable Clamp
(dimension: metric screw thread size [M])
Fastening length:
depends on the number of stacked
VR-Series. Cable Clamp dimension and
type of substructure
Application with Elastic Inlays:
on-site fi xing with any form of adhesive (e.g.
glue, silicone or paste) will void the warranty
immediately
Alternating, tighten nuts with an appropriate torque wrench. Do not
use self-securing/self-locking nuts, this prohibits a defi ned tightening
torque. Tightening Torque for more rows of VR-Series: 8 Nm
Only fl at washers may be used.
No spring or snap rings!
Tightening Torque: 20 Nm
2x
2x
Tightening Torque: 8 Nm
2x
2x
List of individual components:
Clamps for parallel
fastening type
Outer diameter
of cable
Metric screw
thread size (M)
Recommended
thread length*
VR2 12-45
21-45 mm**
M 10
125 mm + x
VR3 12-45
21-45 mm**
M 10
125 mm + x
* For maximum permited outer cable diameter (can be reduced accordingly for smaller diameters)
** Contact îd-Technik for diameter 12-21 mm, please.
x
corresponds to the height of the substructur.
It is essential to respect the specifi ed tightening torques, especially for the top part, to guarantee
perfect and reliable functioning of the cable installation for the long-term.***
Technical changes and errors reserved.
Page 2 of 2
Date 09/2023
*** Contact îd-Technik for trailing cables (EPDM, rubber, etc.), please.
îd-Technik GmbH
, Hohe Strasse 34-36, 68526 Ladenburg, Germany,
Tel.: +49 (0) 6203 40 151 60, www.id-technik.com, info@id-technik.com
