Model 252
Label Printer/Applicator
Operators/Technical Manual
68
6 Save/Recall
The Save and Recall menus allow users to save three, and recall four, different label,
application and product configurations.
The applicator configuration is stored as well as the set values. Recalling a
wipe on setup when a tamp upgrade is installed will cause the tamp not to
operate. Recalling a tamp setup with no tamp installed will cause the
applicator to behave like there is excessive apply delay.
Record the settings for each location in the table provided at the end of this
section.
6.1 Save Configuration
Three individual machine configurations can be saved in numbered buffers. For
example; a machine configuration for label #1 has Delay and Dwell settings that vary
from the configuration used for label #2. After completing the configuration for label #1,
save the settings to buffer #1. When the configuration for label #2 has been completed,
save the settings to buffer #2. This will allow the operator to recall and apply the settings
for the label being applied (label #1 or label #2) in order to reduce changeover time.
To save a setup to a buffer, complete the settings needed for proper printing and
application of the desired label/product combination.
Press the Save Setup icon to open the save menu.
To save the setup you selected in a session to one of the three buffers
listed, press the icon
with the buffer number where you want to save the settings.
Note: The Save Factory buffer can only be accessed by factory technicians and
representatives.
Press the “Enter” icon
to save the settings. Annotate the saved setup on the table
provided in this manual. Enter the parameter set with either an “X” or the numeric value
used. Note: This will overwrite any previously stored settings.
Summary of Contents for 252
