ClearMark™
Installation, Operation & User Manual
–
Page 35
V 1.S.10 January 2021
V-1.S.1
Code selection
The printer lets you select a message stored in memory. To do this:
1.
Press 'SELECT' button for 2 seconds. When you release it, you can begin to select the
code.
2.
Now, press the
‘SELECT’
button N times quickly (< 1s) to indicate the message number
you want to print.
The code number corresponds to its place in the alphabetical order in the printer's
memory.
3.
To confirm the selection, press the
‘SELECT’
button again for more than 2 seconds.
4.
When you release the button,
the ‘SELECT
' LED will confirm the code number that has
been selected by flashing the same number of times as the message code number.
Start-up operations
Printer start-up follows a specific LED sequence until printer is ready.
For firmware versions v.2.3.0 and higher, there are additional functions available that can be
executed while the printer is in boot mode. To access to these operations, press the buttons as
indicated below. This must be performed as soon as LED 1 (ERROR) and LED 3 (SEL) (see
) are ON. The buttons must remain depressed until the LED sequence is
finished. (LED1 ON-> LED2 ON-> LED3 ON-> all OFF.).
Start-up operations available are:
Operation
Sequence
Restore printer’s
configuration to
default
Press ON/OFF button, Purge button and Select button at the same
time.
Update firmware
This operation is only available if there is an USB connected.
Press ON/OFF button and Select button at the same time to initialise
the update firmware process.
Restore network’s
configuration to
default
Press Purge button and Select button to restore network
configuration to default.
NOTE
: is not possible to select a message that is on the USB stick. Messages must first be
copied into the internal printer memory. To perform this, please see the previous section.
