01
02
03
04
05
O
A
06
F
07
08
09
10
11
12
C
13
P
14
F
RF
15
I
16
17
18
MODULE INSTALLATION PROCEDURE - 1 OF 1
START vehicle. Verify all vehicle
functionalities. If the vehicle displays error
messages or any malfunction: stop the
installation and service the vehicle.
Turn ignition to OFF position. Remove keyfob
from keyport.
Verify all keyfob functionalities (Door Lock,
Door Unlock, Trunk Release and Comfort
Access System if equipped).
Insert the expansion pack into module.
Use the EXPANSION CABLE to connect the A
connector to the module and the O connector
to the expansion pack.
Connect the module to the computer with the
programming cable and fl ash the module with
the latest fi rmware. (F port)
Connect and secure every connector to the
vehicle, as shown in STEP 1 of the WIRING
DIAGRAM.
WARNING: Any vehicle harness that is
disconnected during installation, must be
re-connected before performing any system
tests. Failure to comply will result in vehicle
displaying error messages. An OEM scantool
will be required to clear the error messages.
START vehicle. Verify all vehicle
functionalities.
WARNING: If the vehicle displays error
messages or any malfunction, stop the
installation, verify every connection and if the
problem persists, call technical support.
Turn ignition to OFF position. Remove keyfob
from keyport.
Connect the C connector to the module, as
shown in STEP 2 of the WIRING DIAGRAM.
Connect the P connector to the module, as
shown in STEP 3 of the WIRING DIAGRAM.
If required, connect a compatible RF Kit, as
shown in STEP 4 of the WIRING DIAGRAM.
If required, connect a compatible Telematics
Device, as shown in STEP 4 of the WIRING
DIAGRAM.
If the vehicle is not equipped with a factory
hood switch, install an aftermarket hood
switch as shown in STEP 4 of the WIRING
DIAGRAM.
Put sticker 1 on a clean and visible surface
in the engine bay and put sticker 2 under the
dashboard near the OBDII connector.
Module installation procedure completed.
compustar.idatalink.com
Automotive Data Solutions Inc. © 2013
Page 5 oF 16
• 20130723
COM-IDS(RS)-BM1-EN
DOC.: #11866