Ide Line 741-048, User Manual

8

9

8

9

PRIOR TO FIRST USE

•  Remove the protective film from 

the soleplate (2).

•  Heat to maximum temperature and 

run over a damp cloth or similar 
for a few minutes before using on 
clothes.

•  Some parts of the appliance were 

oiled during manufacture and 
these will therefore smoke slightly 

when the iron is first used. This is 

entirely safe, and the smoke will 
disappear once the appliance has 
been used a few times.

USE
Filling with water (only for steam 
ironing)

•  Disconnect from mains and 

turn the thermostat dial (0) to 
MIN (if the appliance has been 
connected).

•  Remove water reservoir filler cover 

(2) (see picture), and fill water to 

the MAX mark ().

•  Close the water reservoir cover.

Setting the temperature

•  Push function button () to b. (see 

illustration below). 

•  Select the required iron 

temperature using the temperature 
control dial:

Setting   Temperature    Use
  •              

80-20 ºC 

  Synthetic fabrics             

                                             (nylon, polyester, 
                                               acrylic, etc.)

  ••

               20-60 ºC    Wool, silk            

                                             or blends
  

•••

            60-205 ºC   Cotton or linen

•  Stand appliance upright. Plug in 

and switch the power on. 

o  The orange thermostat lamp (9) will 

light and the display (6) will show 
current temperature.

•  Do not start ironing until the 

thermostat light (9) goes out. 

o  The thermostat light switches 

on and off during ironing, as 
the thermostat regulates the 
temperature of the appliance.

o  If you turn the temperature up 

using the temperature control dial 
the thermostat lamp will light. Do 
not continue ironing until it goes 
out.

Steam ironing

Steam ironing is only possible at 
high temperatures. Do not use steam 
ironing when the temperature control 
dial is at position •. If you do, water 
runs out from the soleplate, because 
the appliance is not hot enough to 
convert all water to steam.

•  Check that there is sufficient water 

in the reservoir.

•  Turn the thermostat button the 

required position (at least •• ), and 
wait until the light goes out.

•  Push the function selector 

backwards or forwards to select 
steam setting (see picture). You 
can choose between the following 
settings:

a.  Automatic 

cleaning (see 
‘Cleaning’ 
section)

b.  No steam 

(not visible on 
picture)

c.  Minimum 

steam

d.  Maximum steam
 

The appliance produces 
continuous steam from the 
soleplate at settings c. and d. Start 
steam ironing.

o  Push the function selector to 

setting b to switch to dry ironing.

Spray function

This function moistens the item you 
are ironing when you want to remove 
creases. 
•  Press the spray button (5). The 

appliance pumps spray from the 
spray nozzle ().

Dry ironing

Dry ironing uses the same method 
as steam, but the function selector 
should be in position b.

Steam shot function

The steam shot function can be used 
to remove dirt or folds from hanging 
clothes, curtains etc.
•  Set the function selector to 

maximum steam (setting d.).

•  Hold the appliance vertical close to 

the material to be ironed and press 
the steam shot button (4).