Ide Line 753-093 User Manual Download

Page: 20 / 43

KEY TO THE MICROWAVE OVEN’S PARTS

A. Control panel

B. Spindle

C. Turning ring

D. Glass turntable

E. Window

F. Door

G. Dowels (safety lock)

H. Cooking grid

OPERATING PANEL:

1. Display

2. Button for automatic defrosting

(Defrost By W.T)

3. Button for setting clock/timer

(Clock/Pre-Set)

4. Button for defrosting by time

(Defrost By Time)

5. Button for selecting auto-menu (Auto

Cook)

6. Start button (Quick Start/Start)

7. Function button (Micro/Grill/Combi)

9. Knob for setting time, power and

weight (Time/Power/Weight)

SYMBOLS ON THE DISPLAY

(a) Microwave

(b) Grill

(d) High power

(e) Low power

(f) Clock/timer

(g) Child lock

(h) Pre-set programs

(i) Gram (g)

(j) Millilitre (ml)

PREPARING THE MICROWAVE OVEN

Each individual microwave oven is checked at the factory, but for
safety’s sake, after unpacking the oven, you should check
carefully that the microwave oven has not been damaged during
transport. Check whether there is any visible damage (e.g. in the
form of dents or similar), if the door closes properly, and if the

hinges are in order. If it appears that the microwave oven has
been damaged, you must contact the shop where you bought it,
and do not use it until it has been checked by an authorised
specialist.

Before using the microwave oven, you should check that you
have removed all packaging from it both inside and outside.

Positioning the microwave
The microwave oven should be placed on a flat surface, with
clearance of at least 10 cm at the rear, 5 cm at the sides and 20
cm above to ensure sufficient ventilation. Do not remove the feet
of the microwave oven. This oven is not suitable for fitting in, and
you must check that the vent holes on the top of the cabinet are
not covered. If they are covered while the microwave oven is in
use, there is a risk of it overheating. The microwave oven cannot
then be used until it has cooled down.

Do not place the microwave oven or the cord near hot areas, for
example gas rings and electric hotplates.

Connecting the microwave oven
The microwave oven must be connected to a 230-volt AC
current, 50 Hz. The guarantee is not valid if the microwave oven
is connected to the wrong voltage.

Installation of the glass turntable
Before using the microwave ensure that:

•

the turning ring (C) is in the recess around the spindle (B), and
that

•

the glass turntable (D) is fitted to the turning ring.

Setting the clock
When you have lugged the microwave oven in, the display shows
"0:00".

1. Press the button to set the time (3) once. The hour number

now flashes.

2. Turn the knob (9), until the display shows the required hour.

3. Press the button to set the time (3) again. The minute number

now flashes.

4. Turn the knob (9), until the display shows the required minute.

5. Press the button to set the time (3) again to enter the setting.

OPERATING THE MICROWAVE OVEN

The microwave oven is operated in the following way.

•

Place the food to be cooked in the microwave oven and
close the door (F).

•

Select the cooking function and power and preparation time,
if relevant (described in detail below). The microwave oven
starts automatically.

•

Cooking can be interrupted at any time by pressing the stop
button (8). One press temporarily interrupts cooking, two
presses permanently interrupts cooking. Cooking can also be
interrupted temporarily by opening the door. A temporary
interruption to cooking can be cancelled by pressing the start
button (6).

•

Once the cooking time has passed, the microwave oven
stops automatically and 5 beeps are heard.