- 6 -
1. To Charge the Battery
Battery must be fully charged before use the first time!
Connect the charger cable to charging socket on headset
Plug the charger to a power source
Indicator light shows red, when fully charged the red light is turned off
Disconnect charger from headset and from power source
2. To Switch the Headset Power on/off
To power on: press and hold answer/end key for about 3 seconds until indica
tor light flashes blue
To power off: press and hold for about 6 seconds, indicator light is turned off
3. To Pair the Headset with a Bluetooth Enabled Phone
Turn on headset, in standby mode
Set the phone to search for Bluetooth device
When phone finds headset, confirm by selecting the headset from list
Enter passcode 0000 when prompted by phone
Repeat steps (b.) – (d.) If the pairing was unsuccessful, only need to pair once
If pairing was successful, indicator light starts to flash blue, indicating in
standby mode and ready to make/receive calls
4. To Answer a Call
Press the answer key on your phone, or
Press and hold the answer/end key on headset briefly
5. To End a Call
Press the end key on your phone, or
Press the answer/end key on headset briefly
6. To Reject a Call
Press the end key on your phone, or
Press and hold the answer/end key for at least 2 seconds when phone is rin
ging
7. To Make a Call
Dial the number from your phone, then press the answer/call key on your
phone, call is automatically transferred to the headset
standby mode
