79
OTHER COMPONENTS
38
Quick-release clamp
WARNING
Risk of accident and injury!
If quick-release clamps are not closed or adjusted properly, they can open while
you are riding and cause the corresponding components to come loose.
»
Before setting off, make sure that all quick-release clamps are closed properly
with sufficient initial tension and resting against the component or frame.
»
You should only remove or install wheels with quick-release axles yourself if you
have sufficient technical knowledge. Otherwise, contact your specialist dealer.
CAUTION
Risk of injury!
If you operate a quick-release clamp without due care, you could crush your fingers.
»
Take extra care when opening and closing the quick-release clamp and take care
not to get your fingers caught.
Components secured with quick-release clamps are quick to adjust, remove and install
without using tools.
1
2
1
Tensioning screw
2
Quick-release lever
Fig. 24:
Quick-release clamp
Opening and closing a quick-release clamp
• Open the quick-release clamp by pulling the lever outwards (away from the component
that it is resting against when closed).
• Close the quick-release clamp by pushing the lever against the corresponding compo-
nent until it is resting against it.
• The quick-release clamp should be adjusted if you notice that it is not holding the
component securely in place or if it closes too easily.
• Have your specialist dealer replace any worn or damaged quick-release clamps with
suitable original spare parts.
Summary of Contents for PRISMA-810
Page 1: ...BMIEEN22V01 Original Instructions EN 15194...
Page 99: ...99 NOTES...
Page 100: ...BMIEEN22V01...