16
Buccaneer GTE -
Installation & Servicing
INSTALLATION
5
4
1
1
3
3
1
2
buc5507
22 INSTALLING THE SENSORS
1.
Insert the sensors in the
sensor pocket at the back
of the boiler.
2.
Use the sensor pocket
contact spring (delivered
in the casing instructions
pack) to separate the
sensors. Secure the
cables in place using the
sensor pocket spring.
Note.
Route the sensor
cable/capillary on the
opposite side from mains
electrical wiring.
23 INSTALLING THE SIDE PANELS
1.
Put the front of the side panel into place,
engaging the lower notch of the panel in the
cross bar of the base.
2.
Make sure that the lower fold in the panel is
correctly positioned under the fold of the cross
bar.
3.
Straighten the side panel and pull
it upwards.
4.
Attach the side panel to
the lugs of the control
panel support, pulling its
upper fold upwards such
that the upper fold of the
side panel is centred
and blocked between the
two notches.
5.
Fix the side panels using
2 self tapping screws
and serrated washers.
Note.
Take care to route the
burner cable through the
notch at the front edge of the
side panel.
1
2
- boiler sensor
- safety thermostat bulb
Back view
Contact spring
buc5506
INST
ALLA
TION
Summary of Contents for Buccaneer GTE 5
Page 1: ......
Page 38: ...38 Buccaneer GTE Installation Servicing NOTES...
Page 39: ...39 Buccaneer GTE Installation Servicing NOTES...
