2
icos system -
User's
Introduction
The
icos system
is a wall mounted, room sealed, condensing
boiler, featuring full sequence automatic spark ignition and fan
assisted combustion.
Due to the high efficiency of the boiler, condensate is produced
from the flue gases and this is drained to a suitable disposal point
through the plastic waste pipe at the lower rear of the boiler. A
condensate 'plume' will also be visible at the flue terminal.
Safety
Current Gas Safety (Installation & Use)
Regulations or rules in force.
In your own interest, and that of safety, it is the law that this boiler
must be installed by a CORGI registered installer, in accordance
with the above regulations.
It is essential that the instructions in this
booklet are strictly followed, for safe and
economical operation of the boiler.
Electricity Supply
This appliance must be earthed.
Supply: 230 V ~ 50 Hz. The fusing should be 3A.
Connection must be made in a way that allows complete isolation
of the electrical supply such as a double-pole switch, having a
3mm (1/8") contact separation in both poles, serving only the
boiler and system controls. Alternatively, a 3-pin UNSWITCHED
socket may be used. The means of isolation must be accessible
to the user after installation.
Important Notes
z
z
z
z
z
This appliance must not be operated without the casing
correctly fitted and forming an adequate seal.
z
z
z
z
z
If the boiler is installed in a compartment then the
compartment MUST NOT be used for storage purposes.
z
z
z
z
z
If it is known or suspected that a fault exists on the boiler then
it MUST NOT BE USED until the fault has been corrected by a
CORGI registered installer.
z
z
z
z
z
Flammable materials must not be placed in close proximity to
the appliance. Materials giving off flammable vapours must
not be stored in the same room as the appliance.
z
z
z
z
z
Under NO circumstances should any of the sealed
components on this appliance be used incorrectly or
tampered with.
In cases of repeated or continuous shutdown a CORGI registered
installer should be called to investigate and rectify the condition
causing this and carry out an operational test . Only the
manufacturers original parts should be used for replacement.
Minimum Clearances
Clearances of
165mm (6 1/2"
) above,
100mm (4"
) below,
5mm
(1/4"
) at the sides and
450mm (17 3/4
") at the front of the boiler
casing must be allowed for servicing.
The minimum front and bottom clearance allowed when built into
a cupboard is 5mm.
icos system m3080
(Natural Gas Only)
G.C. Appliance No. 41-391-52
Destination Countries: GB, IE
All CORGI Registered Installers carry a CORGI ID card, and have a registration number. Both should be recorded in your
Benchmark
Log Book. You can check your installer by calling CORGI direct on 0156 372 300.
THE LOG BOOK SHOULD BE COMPLETED AFTER
EACH SERVICE AND KEPT WITH THESE
INSTRUCTIONS.
Summary of Contents for icos system m3080
Page 1: ......
Page 51: ...51 icos system condensing Installation and Servicing NOTES ...
Page 53: ......
