23
Mexico Super CF 3/60P - 3/140P -
Installation
32 CLEANING THE BURNER ASSEMBLY
SER
VICING
SERVICING
5.
Inspect the pilot burner, thermocouple and ignition electrode
- ensure that they are clear and in good condition. Check that:
a.
The pilot burner is clean and unobstructed.
b.
The ignition electrode is clean and undamaged.
c.
The ignition lead is in good condition and securely
connected.
d.
The ignition gap is correct. Refer to Frames 46 & 47.
e.
The thermocouple tip is not burned or cracked.
f.
The position of the thermocouple relative to the pilot
burner is correct. Refer to Frames 46 & 47.
g.
The thermocouple terminal at the gas valve is clean.
6.
Clean or renew components as necessary.
1.
Clean the lint gauze(s) to remove any deposits of lint, fluff
etc.
2.
Brush off any deposits that may have fallen on to the burner
head, ensuring that the flame ports are unobstructed, and
remove any debris that may have collected.
Note.
Brushes with metallic bristles MUST NOT be used.
3.
Remove the main burner injector(s). Check, clean or replace,
as required.
4.
Refit the injector(s), using an approved jointing compound.
33 CLEANING THE LOWER FRONT PANEL LINT ARRESTING GAUZE
- CF 3/100P, 3/125P & CF 3/140P ONLY
1.
Unclip the gauze from the grille assembly and lift
it clear of the bottom return edge.
2.
Clean the gauze to remove any deposits of lint or
fluff.
3.
Refit the gauze by entering the bottom edge
behind the grille return edge and engaging the
top in the clips.
Summary of Contents for Mexico Super CF 3/60P
Page 1: ......