background image

Supplied By www.heating spares.co  Tel. 0161 620 6677

users guide

Mexico Super

Your Ideal users guide

See reverse for 

Mexico Super

 installation & servicing instructions

ENGINEERED FOR PEACE OF MIND

When replacing a part on this appliance use only spare parts that you can be assured 
conform to the safety and performance specification that we require. Do not use 
reconditioned or copy parts that have not been clearly authorised by Ideal Boilers.

CF445, CF455, CF465 & CF475

200943-1.p65

3/4/2004, 2:25 PM

37

Summary of Contents for Mexico Super CF445

Page 1: ...ing instructions ENGINEERED FOR PEACE OF MIND When replacing a part on this appliance use only spare parts that you can be assured conform to the safety and performance specification that we require Do not use reconditioned or copy parts that have not been clearly authorised by Ideal Boilers CF445 CF455 CF465 CF475 200943 1 p65 3 4 2004 2 25 PM 37 ...

Page 2: ...iodically that the ventilation areas are free from any obstruction c If it is known or suspected that a fault exists on the boiler then it MUST NOT be used until the fault has been corrected by a CORGI registered installer or in IE a competent person d Inflammable materials must not be placed in close proximity to the appliance Materials giving off flammable vapours must not be stored in the same ...

Page 3: ...tem installed or as recommended by the installer To Shut Down the Boiler 1 For short periods Turn the boiler thermostat knob G to OFF When heating is again required restore the knob to its original setting 2 For longer periods a Turn the boiler thermostat knob G to OFF b Switch the electricity supply to OFF LEGEND A Gas control valve B Burner pressure test point C Main burner pressure adjuster D I...

Page 4: ...fter refilling contact the installer Has there previously been a smell of fumes from the flue It is likely that the downdraught thermostat has operated due to the combustion gases not being evacuated from the flue Contact your installer to check the flue is operating correctly and not blocked etc Boiler goes through ignition sequence but fails to light in either mode Check gas supply try at anothe...

Reviews: