Caradon Ideal Limited
pursues a policy of
continuing improvement in
the design and performance
of its products. The right is
therefore reserved to vary
specification without notice.
Ideal Boilers, P.O. Box 103,
National Ave., Kingston upon
Hull, HU5 4JN. Telephone:
01482 492 251.
Fax: 01482 448 858.
Registration No. London 322 137.
The code of practice for the installation,
commissioning & servicing of central heating systems
Caradon Ideal Limited is a member of the Benchmark
initiative and fully supports the aims of the
programme. Benchmark has been introduced to
improve the standards of installation and
commissioning of central heating systems in the UK
and to encourage the regular servicing of all central
heating systems to ensure safety and efficiency.
Ideal Consumer Helpline Tel: 01482 498 660
www.idealboilers.com
THIS SYMBOL IS YOUR
ASSURANCE OF QUALITY
These appliances are designed for use with Natural
Gas only. They have been tested and conform with the
provisions of BS. 6332 and BS. 5258.
CERTIFIED PRODUCT
Manufactured under a BS EN
ISO 9001:2000 Quality System
accepted by BSI.
Natural Gas appliances are service
listed by British Gas
Boiler overheat thermostat (if fitted)
If the boiler is fitted with a safety 'cutout' thermostat this will
shut down the boiler in the event of overheating.
Should this occur allow the boiler to cool, press the reset button
(D) then relight as detailed in steps 1-7 in 'To light the boiler'.
If the cutout condition still persists then turn off the boiler and
consult a CORGI registered installer or in IE a competent person.
Loss of system water pressure
(Boilers fitted with Classic Sealed System Units only)
If the red arrow on the module pressure gauge is set above zero
and the system pressure is seen to fall below this value over a
period of time then a water leak is indicated. In this event a CORGI
registered installer or in IE a competent person should be
consulted.
DO NOT OPERATE THE BOILER IF THE PRESSURE HAS
REDUCED TO ZERO FROM THE ORIGINAL SETTING.
Escape of gas
Should a gas leak be suspected, contact your local gas supplier
without delay.
Do NOT search for gas leaks with a naked
flame.
Cleaning
For normal cleaning simply dust with a dry cloth.
To remove stubborn marks and stains, wipe with a damp cloth
and finish off with a dry cloth.
Do NOT use abrasive cleaning materials.
Maintenance
The appliance should be serviced at least once a year by a
CORGI registered installer or in IE a competent person.
