Chapter 3
Calibration, Configuration, and Special Operations
3-41
4.
Select the tone, press
and select LOW, HIGH, or WARBLE using the soft
keys.
To activate the Tone Generator using the Remote Handset:
1.
Connect the RH to the cable under test.
2.
Press
on the RH to enter Tone mode. The RH two-line display shows
the first line
TONE
, the second
line shows a
XY
form of
characters.
X Character
(Tone Type)
Y Character
(Placement of tone)
L = Low
A = Pair A
H = High
B = Pair B
W = Warble
C = Pair C
D = Pair D
Example: LA = Low tone, Pair A
Note: The Tone mode will remain active until
is pressed or no test activity has
been performed after the past five minutes.
3.
Select the pair on which to place the tone by cycling the
Tone
key.
4.
Select the tone for the selected pair by cycling the
Tone
key.
Summary of Contents for LANTEK
