1. The Halo can be installed with
or without the provided trim plate.
3. Insert the 4 AA batteries provided into the front
housing of the Halo. Pay close attention that the
orientation of the batteries is as indicated in the
housing.
4. Locate the front housing (display) in position
paralell to the rear housing and clip
into place.
2. If no trim plate is required, use the rear housing
of the Halo to position the unit on the wall,
alternatively secure rear housing to trim plate.
Take care not to overtighten the screws.
C. INSTALLATION OF THE HALO
The Halo can be either wall mounted or desk mounted.
Wall mounting the Halo
If there are any concerns regarding signal strength and location of the wall mounted Halo it is advisable to
pair the control (section E) and check signal strength before fixing to the wall.
