4
Test in Progress - Cable Test
1. When the test is running, “Test” blinks;
when test is completed, “Pass” or “Fail”
shown;
2. Remote ID shown when wire map
passes;
3. The last line shows the length of cable being tested;
4. Beeper icon appears only when Beeper is OFF; low battery icon appears
only when the battery is below 5.5V
Results of a correctly wired good shielded cable:
1. When the test is running, “test result
shows “Pass”;
2. Remote ID shown when wire map
passes;
3. The last line shows the length of cable
being tested;
4. Beeper icon appears only when Beeper is OFF; low battery icon appears
only when the battery is below 5.5V
Results of a cross-over, shielded cable:
1. “Pass” shown on the first line;
2. Wire Map shows wiring configuration
3162
and ID # indicates the particular
Remote which is in use;
3.
“M12>RJ45 X-Over” displayed on
the last line ;
4. Beeper icon appears only when Beeper is OFF; low battery icon appears
only when the battery is below 5.5V
Results of a 2-pair cable, where 1-2 pair found open
1. When a pair of wire was found open,
the two missing pin numbers in line 2
of the wire map indicates the open pair;
2. The last line shows an error message
“Open 1-2”
Test
M12>RJ45
1234 No Shield
ID 1
1.5m
PASS
M12>RJ45
1234 Shielded
1326
ID 1
1.5m
PASS
M12>RJ45
1234 Shielded
3162
ID 1
M12>RJ45 X-Over
Fail
M12>RJ45
1234 Shielded
3 6
ID 1
Open 1-2
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com
