12
TLX-7000
Aug 2021
To Lower Vehicle:
·
Ensure area around & under the lifted / tilted vehicle is clear of any obstructions that may interfere with
vehicle coming down.
·
Carefully, remove Jack Stand from under vehicle. Ensure to locate Stand clear of vehicle & lift.
·
Remove Safety Locking Pin. Insert into storage position on lift.
·
Insert Drill Adapter into the Gearbox Socket, using the
‘forward & reverse’ function of power drill to
lower lift. Double check rotation of drill to lower lift, as noted on UP & DOWN arrows for each Gearbox.
·
Slowly lower vehicle until all four wheels are touching the ground and the lift Platforms are clear of the
vehicle frame.
·
Once lift is completely lowered, roll lift out from under vehicle and store for later use.
Never Drive Over Tilt Lift!! Damage to Vehicle and Tilt Lift Will Occur!
To Tilt Vehicle:
·
Vehicles come in different sizes, configurations, engine locations & weights.
Refer to the Basic
Vehicle Layout Positions, noted on page 10.
You may need to adjust the lift’s position ‘front or back’ an inch or two in order to obtain
easy vehicle tilting. Once the best balance placement for the lift & vehicle has been
established, it is recommended to mark the underside of vehicle for future usage.
·
In order to tilt the vehicle, carefully lift vehicle from the lowered end that has wheels touching the
ground.
Never Pull Down from the Vehicle End that is Raised. Damages to Vehicle may Occur.
·
Ensure to lift to tilt vehicle from a solid part of the of the vehicle, like the fender, bumper, frame, etc.
Never Lift & Tilt Vehicle from Fragile Decorative type Parts of Vehicle.
·
Once the vehicle starts to rise & tilt, control rise by using two hands to control vehicle transitioning onto
the opposite wheels. Try not to let the vehicle bounce, as damages may occur.
·
Always position Jack Stand under the tilted vehicle to ensure vehicle will not unexpectedly tilt back or
down while working on vehicle.
When raising, lowering and especially tilting vehicle, ensure there is enough room under
the bumpers, so damages will not occur.
