7
TLX-7000
Aug 2021
Tilt Lift Assembly
1. Raise Frame Arms up so both pivot holes align to each other. Locate Pivot Bars, Flat Washers,
Spacers & Nylon Nuts to mount Platforms. (Slightly coat interior of pivot holes with lithium grease.)
2. Insert Pivot Bar into Frame Arm holes. Apply Flat Washers to each side, as shown below.
3. Bias Pivot Bar to outside & slightly tilt Platform down to insert Bar thru the outer hole (A); then level
to inner Platform hole (B) to fully insert Pivot Bar. Insert Spacers to each side, as shown below.
A.
B.