- 22 -
P
O
•
Operation
•
Cutting activation
Warning!
•
Run backgauge to the front for turning the
paper stack
•
Do not interrupt the upward movement of the
blade by performing switching procedures
•
Wait until the display is green before
activating a cut
•
Blade must always be at the top and be
covered by the clamp. Do not touch the
blade.
Risk of injury!
Cutting to specified dimensions
•
Press MANUAL
•
Enter dimension on the numerical
key pad
O
Measurement is shown in red
(If a wrong dimension is entered this can be
corrected by pressing the CLEAR button)
•
Press START
P
dimension is
approached,
Measurement is shown
in green
•
Insert paper and move by means of the
stacking angle
Q
to the backgauge
I
and
side lay on the left
J
•
Release the cut.
Cut according to markings
•
Press MANUAL
•
Adjust the backgauge with the
hand-wheel
G
to the back
•
Insert paper and move by means of the
stacking angle
Q
to the backgauge
I
and
side lay on the left
J
•
Turn the hand-wheel
G
to the right until the
marking on the paper to be cut is below the
cutting line indicator
•
The further the hand-wheel
G
is turned to the right, the quicker the
backgauge moves. If the hand-wheel is
turned to the left the backgauge will return
quicker.