- 22 -
AP 40
Filter Assembly
Filters should be re-assembled in the reverse order of their removal.
①
Insert the
Anti-microbial HEPA filter
and
Carbon deodorization filter, in
that order.
x
Be sure to remove the plastic wrap from new
filters.
Operating the unit without removing the
plastic wrap from the filters may cause
abnormal noise, deformation, or fire from
overheating.
Anti-microbial
HEPA filter
Carbon
deodorization
filter
②
Insert the
Pre-filter.
x
Fit this pair of filters into the grooves on
either side of the lower part of the unit, and
then insert the tabs at the top and gently
push until both sides of the middle section
audibly click into place.
③
Replace the front panel by first inserting
the latch at the bottom edge and then
snapping the upper part shut.
X
Only genuine Winix filters should be used with this unit.
Filter einbauen
Der Filtereinbau erfolgt in umgekehrter Reihenfolge.
Setzen Sie zuerst den Antimikrobiellen
True HEPA Filter und danach den CD
Aktivkohle Filter ein.
Stellen Sie sicher, dass Sie die Plastikfolie
des neuen Filters vor dem Einsetzen entfernt
haben. Das Einsetzen eines Filters mit
Plastikfolie kann zu ungewöhnlichen
Geräuschen, Verformungen oder sogar
Feuer führen.
Antimikrobieller
True HEPA-Filter
CD Aktivkohle
Filter
Einlegen des CleanCel
®
Fein Filters.
Um die Montage abzuschließen, setzen Sie
den CleanCel
®
Fein Filter in die untenste-
henden dafür vorgesehenen Aussparungen
ein und drücken Sie dann den oberen Teil
in Pfeilrichtung nach innen, bis er hörbar
einrastet.
Setzen Sie die Frontplatte ein, indem
Sie die beiden untenstehenden Riegel in
die dafür vorgesehenen Aussparungen
einsetzen und das Oberteil ans Gehäuse
andrücken. (Magnet)
Es dürfen nur originale IDEAL Health Filter
verwendet werden.
Hinweis
Summary of Contents for AP 40
Page 86: ... 86 AP 40 Notizen Remarks Notes ...
Page 87: ... 87 Notizen Remarks Notes ...