background image

Ideal Boilers

, P.O. Box 103, National Ave, Kingston upon

Hull, HU5 4JN. Telephone:  01482 492 251 Fax: 01482
448 858. Registration No. London 322 137.

Ideal Stelrad Group

 pursues a policy of continuing improvement in the

design and performance of its products. The right is therefore reserved to
vary specification without notice.

November 2007                204041 A01

Ideal Consumer Helpline Tel: 01482 498 376

www.idealboilers.com

To Shut Down the Boiler

1. For short periods

Set the boiler on/off switch (1) to OFF.

2. For longer periods

Set the boiler on/off switch (1) to OFF, wait 10 minutes then
switch the electricity supply to OFF.  For longer periods the
entire system should be drained, including the domestic
hot water supply.

To Relight the Boiler

Refill the system if it has been drained, taking care to ensure
no air is in the boiler or system.

Repeat the procedure detailed in 'To light the boiler'.

F r o s t   P r o t e c t i o n

If frost is likely, leave the boiler thermostat at a reduced
temperature setting.  Ensure external controls allow the boiler
to operate if necessary.  Note that this may not protect remote
parts of the system, in which case a separate frost thermostat
should be fitted or the system drained and the boiler shut
down, as for Long Periods.

B o i l e r   O v e r h e a t   T h e r m o s t a t

Boiler overheating is detected by  the overheat thermostat
connected to the boiler control module.  If the boiler overheats, it
will shut down the burner but the circulating pump will continue
to run.  The display may  show 

 until the water cools.

Press the safety thermostat reset button, under the screw top
cap (4), and the burner will relight.  If the fault recurs, turn off the
boiler and consult a recognised installer (CORGI registered for
gas-fired boilers.)

Escape of Gas

Should a gas leak or fault be suspected contact your local gas
supplier without delay.

Do NOT search for gas leaks with a naked flame.

C l e a n i n g

For normal cleaning simply dust with a dry cloth.

To remove stubborn marks and stains use a damp cloth and
mild detergent.

DO NOT use abrasive cleaning materials.

Reviews: