18
Falcon GTE -
Installation & Servicing
INSTALLATION
27 FITTING THE SIDE PANEL SUPPORTS
1.
Place the two lower side pieces (with
the round hole towards the front and
the oblong hole towards the back of
the boiler).
2.
Fix:
a. to the front with a screw, serrated
washer and nut.
b. To the rear with a screw, LL washer
and nut.
3.
Screw the screws home into the notch
of the front height converters.
28 RE-ROUTING THE BURNER CABLE
If the burner cable is not routed on the side
opposite to the hinges of the boiler door (as
required under European standards) proceed as
follows:
1.
Open the control panel (two screws and
serrated washers on the rear).
2.
Relocate the burner cable on the opposite side
and route it on the outside of the crossbar.
3.
Relocate the grommet and pass the cable
through it.
4.
Refit the control top panel.
FAL5838
2
2
1
1
2
3
FAL5839
29 ASSEMBLING THE SIDE PANELS
1.
Insert the side panels from the
bottom into the notches on the
lower side pieces.
2.
Put the side panels in contact with
the upper rear crossbar.
3.
Fit 2 screws loosely and lift the
panels up slightly and fit them in.
4.
Fix them to the front of the control
panel with two self tapping screws
and serrated washers.
5.
Tighten the screws of the rear
crossbar.
FAL5840
2
5
4
3
1
INST
ALLA
TION
