14
FP14KC-X
JAN 2023
6)
Insert the steel Lift Cable through the Top Plate for each Post, as shown in
Fig 14
. Secure Cable End
to the top of each post using
M20
Hex Nut & Washer. Ensure the Lift Cable is routed correctly on the
Slack Cable Roller, as shown in the
Fig 15
.
Fig. 14 Fig. 15
CAUTION!
Ensure the Lift Cables are not twisted and are fully engaged in the grooves of the
Crossbeam Cable Pulleys, while also being properly routed for the Slack Cable Roller.
7)
Locate the Plastic Crossbeam Covers and mount to the top of each Crossbeam ends using the Plastic
Insert Screws,
Fig 14
.
8)
Re-install Cable Guide Tabs to the underside of each end of Crossbeam, using the
M6 x 12mm
Screw
& Lock Washer, shown below in
Fig. 16
.
9)
Secure the Latch Racks to the back of each Post, using the
M8 x 12mm
Screw & Flat Washer, shown
in
Fig 17
.
Fig. 16 Fig. 17
Lift Cable
Slack Cable
Roller
Lift Cable
M20
Hex Nuts
& Washer
Top Plate
Cable
Pulley
Lift Post
Plastic
Crossbeam
Cover
Plastic
Insert
Screws
Cable Guide
Tab
(Underside)
M6 x 12mm
Screw & Lock
Washer
M8 x 12mm
Screw & Flat
Washer
Latch
Rack
