General Specifications
V connector:
1100 Vp AC+DC
850 Vp m m
AC+DC
LV
Ω Ω
• )( Hz% DF °C°F
Temperature coefficient:
0.1 X (Spec. Accuracy) per °C, <18°C or >28°C
Battery Life:
100 hours typical (alkaline)
Physical Characteristics
Dimensions:
200mm x 90mm x 42mm
212mm x 100mm x 55mm (w/holster)
Weight (w/battery):
0.4Kg
Weight (w/holster):
0.6Kg
Enviornmental Characteristics
Temperature Operating:
0 to +50°C
Temperature Non-Operating:
-20 to +60°C
Humidity (Operating):
<80% R.H.
Altitude (Operating):
2,222m (7290 ft.)
Altitude (Non-Operating):
12,300m (40354 ft.)
Vibration & Shock (Operating):
MIL-T-28800E Type II Class 5
2.66g RMS, 5 to 500 Hz,
3 axes, (10 min. each)
Dust/Water Protection IP Rating:
IP 64
Certifications & Compliances
Safety:
Designed to IEC 1010-1, UL3111 and CSA
Specifications Input Rating:
1000VDC Category II
600VDC Category III
750VAC Category II
600VAC Category III
Overvoltage Category:
Cat III: Distribution level mains, fixed installations
Cat II: Local level mains, appliances, portable equipment
Cat I: Signal level, special equipment or parts of equipment,
telecommunication, electronics
Pollution Degree 2:
Do not operate in environments where conductive pollutants may be
present.
16
15
Continuity Check
To Verify Continuity:
A continuity test ensures that all circuit connections
are intact.
1. Plug the Black test lead into the COM port and the Red test lead into the V
Ω
Hz port.
2. Set the rotary switch to the position.
3. Press the blue button until is shown in the display.
4. Connect the test leads to the circuit to be measured. The buzzer will sound if the resistance of the circuit
measured is lower than 50
Ω
.
Continuity threshold: Approx. 50
Ω
Continuity Indicator: 2kHz tone buzzer
Input protection: 600V rms
General Specifications
Stated accuracies are at 23°C +5°C at less than 80% RH and without battery indicator displayed.
LCD display digits:
4-1/2 or 3-3/4
Bargraph segements:
42 segment graph
Display count
20,000 or 4,000
Numeric update rate:
2 times/sec (20,000 count)
Bargraph:
20 times/sec
Polarity display:
Automatic
Overrange display:
OL is displayed
Low voltage indicator:
is indicator
Automatic power-off time:
Automatic backlit off = 15 minutes
Power source
One 9V dry cell battery
Maximum input voltage:
1000V (750VAC) Cat II between V and COM
Maximum floatin voltage:
1000V (750VAC) Cat II between any terminal and earth ground
Maximum input current:
200mA between mA and COM 10A continuous between A and COM
(20A for 30 seconds)
Maximum open circuit
600V between A and COM and
Voltage (current inputs):
between mA and COM
Overload protection mA
1A (600V) fast blow fuse connector:
A connector:
15A (600V) fast blow fuse
C
US
