IDEATEC S.A. - Z.I. de Noville-les-Bois - rue Léopold Génicot 19A - 5380 Fernelmont, Belgium - Tel: +32(0)81 42 00 10 - Fax: +32(0)81 57 91 70 - E-mail: info@ideatec.be
User’s guide DLC4000/DLC8000 -
Doc. V2.1 - Firmware V3.1
B4
B3
B2
B1
Page 12
Identification des éléments
Description des éléments
Description du produit
11.
B5
B6
B7
B8
B4
B3
B2
B1
&
Key (4x)
11.3. Keys operation
11.3.1.
No backlighting is present and key B4 is lit briefly every 5 seconds.
This state indicates that the DLC4000 or the DLC8000 is in "sleeping" mode. In this state, the power consumption of
the system is reduced to a minimum and all outputs are inactive. There are two ways of "waking up" the system. Press
the key B4 on the console or to apply a signal to the positive input 1 ("Ignition Key Signal”). With either solution, at that
time, the console will sound a very brief alarm and the console backlighting will be activated. Key B4 will stop sending
its brief light signal. If some outputs are configured in “permanent” mode” (no function on the linked key) then they are
automatically activated.
11.3.2.
The key B1, B2, B3, ... or B4 is permanently lit.
This state indicates that the function associated with that key is activated therefore simply press the key again to turn it
off and desactivate the associated function.
BEEP SOUND SIGNAL
11.2. Description of the different light and sound codes
= OFF
= LIT
= FLASHING
11.1. DLC4000 and DLC8000 consoles
The console DLC4000 with 4 backlit keys and the console DLC8000 with 8 backlit keys allow a pictogram to be
inserted (Fig. 1).
A set of 88 pictograms is provided (Fig. 2).
Fig.1
Fig.2
To make sure that the pictogram adheres properly in the
cavity of each key, you should avoid touching the adhesive
part of the pictograms and the cavity of the keys.
Operation & Configuration
Key (8x)
i
The console backlighting is only visible in the dark or semi-darkness.
Outpout 3 is activated.
Example :
