IDEATEC S.A. - Z.I. de Noville-les-Bois - rue Léopold Génicot 19A - 5380 Fernelmont, Belgium - Tel: +32(0)81 42 00 10 - Fax: +32(0)81 57 91 70 - E-mail: info@ideatec.be
User’s guide DLC4000/DLC8000 -
Doc. V2.1 - Firmware V3.1
Page 23
Identification des éléments
Description des éléments
Description du produit
11.
&
Page 15
B5
B6
B3
B7
B8
B2
B4
B1
0
1
3
4
3X
4X
2
3X
2X
3X
1X
11.5. DLC8000 Configuration - MODE 1 (continued)
Operation & Configuration (continued)
10.5.7. Key B7 configuration (DLC8000 only).
By default the key 7 is a switch available and is linked to positive output 7.
It’s possible to disable the key B7 and to put a black pictogram on the key to notify the user of the console that the key
is not available. When the key is not available then the positive output 7 is permanent output, going off only when
console is off or the power supply of the DLC8000 is disconnected.
Key B7 can be used as arrowstick controller with or without handbrake condition.
Some functions are linked to the negative input 2.
Key B7 is a switch and is included in the group
1
with B5, B6 and B8 if they are
configured in group
1
mode.
See the description of the function group
1
on page 25.
Special conditions with negative input 2 for group
1
are available in configuration mode 2
(see page 28).
Key B7 is a switch and is included in the group
2 with B5, B6 and B8 if they are
configured in group
2
mode.
See the description of the function group
2
on page 25.
Special conditions with negative input 2 for group
2
are available in configuration mode 2
(see page 28).
Key B7 is a momentary push button and activates the positive output 7 when it is
pressed and the positive ouput 7 is going OFF when key B7 is released.
Key B7 is a switch and activates the positive output 7.
No condition.
Key B7 is not available and the positive output 7 is permanent positive output.
SELECTION FLASHES DESCRIPTION
