Base unit settings
46
Troubleshooting
!
The iDECT K1 must be serviced by trained engineers.
NEVER attempt any repairs or adjustments yourself
— you could make the problem worse and invalidate
the Guarantee.
ALWAYS check
first that:
■
you have followed all the steps listed on pages 6 to 7
to install and set up your iDECT K1
■
all
connectors
are firmly inserted in their sockets
■
mains power
is switched on at the socket
■
the handset’s
batteries
are correctly and securely
installed, and are not run down
Everyday use
“I cannot make
or answer calls.”
If the handset’s display is blank, it may be
switched off
.
Press the
HANG UP
button to switch it back on.
Check that the base unit’s
mains power adapter
is
plugged in and
power is switched on
. The base unit
needs mains power for normal operation of the phone
— not just for charging the batteries.
Make sure you’re using the
telephone line cable
that
was supplied with your iDECT K1. Other telephone line
cables might not work.
Move the handset
closer
to the base unit.
Check the
Battery Level
symbol on the display. If it’s
low, replace the handset on the base unit or charger
pod to recharge the batteries.
If
auto-answer
is turned off (page 41), you need to
press any button (except
HANG UP
) on the handset to
answer an incoming call. Turn auto-answer on if you
want to answer calls by simply lifting the handset from
the base unit or charger pod.
Switch off power
at the mains socket, wait for a few
seconds and then
switch back on
. This may help.
Help Line:
0845 345 9677
(Local Call rate)
47
To change the
This is for setting the flash (recall) signal
length, you should not need to change
the setting. Unless you're having problems
using your iDECT K1 on a PBX.
1
2
3
Press the button
Press to go to the [
Base Set
]
è
The display shows [
Short
]
Menu
then press
OK
Press or to select [
Flash Time
]
then press
OK
flash time
[
Medium
]
[
Long
]
4
Select the flash time by or , and
press
OK
to confirm
è
è
è
è
