=7?,--/@KHLQ -.-1.2
12
Operation for Epilation
The Epilator can be used by either cord or cordless operation.
For cord operation, make sure the device is off. Connect the power cord connection of the AC adap-
tor to the socket on the device.
For cordless operation, make sure the device is fully-charged before use.
Remove the protective cap from the unit.
Check if the rotating epilator head has been installed on the unit.
Stretch your skin with your free hand to make the hairs stand upright.
Push the On/Off switch upward: the tweezers start rotating.
#)§%*#))%%*¢%
pressure, just touch the skin. (Figure 1)
Use short, circular movements as if you are brushing or wiping – in the direction the hair grows.
(Figure 2)
Pull the skin taut with your other hand, if necessary. Stretch out your leg when removing hair behind
your knee. (Figure 3)
Figure 1
Figure 2
Figure 3
Hold out your arm to stretch the skin when removing armpit hairs.
To turn the device off, push the On/Off switch downward.
Cleaning
Always switch off unit and unplug the adaptor from the mains before cleaning.
Cleaning the unit after each use.
Remove the rotating epilator head from the unit for cleaning.
Use the cleaning brush (included) to remove all the hairs from the rotating head mechanism and the
housing.
It is no need to clean the discs of the rotating mechanism. However, you can wipe them from time to
time with alcohol to maintain hygiene. Use a cotton bud which you have soaked in alcohol and then
squeezed out. The cotton bud must not be wet.
Never put the appliance in water or any other liquid.
Never use abrasive cleaners, brushes gasoline, kerosene, glass / furniture polish or paint thinner to
clean.
Summary of Contents for RAY-002
Page 6: ......
