IDEMIA DOCUMENT
– REPRODUCTION AND DISCLOSURE PROHIBITED
Power supply
11
External Power Supply:
12-24 Volts (regulated and filtered) 2.5 Amp min @12 V, CEE/EEC EN60950
standard compliant. If sharing power between devices, each unit must receive 2.5 A (e.g. two units would
require a 12 VDC, 5 A supply).
Power Over Ethernet (POE+):
power can be provided through RJ-45 connector
using a PSE (Power Sourcing Equipment)
IEEE802.3at type 2
compliant.
The terminal is a Class 4 (25.5 W) PD (Powered Device).
St
ep
tw
o
:
w
iring
PoE+ Injector Specs
Output Voltage: 48 VDC
Output Current: 0.64 A
Power: 30 W
A battery backup or uninterrupted power supply (UPS) with built-in surge protection is recommended.
WARNING: Under powering may cause memory and data corruption; over powering may cause hardware damage.
Both of these situations will void the warranty
Gauge
AWG
Section
(mm
2
)
Maximum distance (meters)
vs power source rating
12V
+/-10%
12V
+/-5%
24V
+/-10%
16
1.31
9 m
20 m
300 m
18
0.82
6 m
12 m
200 m
20
0.52
3 m
8 m
120 m
22
0.32
2 m
5 m
75 m
IDEMIA recommends using a 24V power supply and AWG16 gauge
cable. The voltage measured on the product block connector of the
terminal must be equal to 12V-24V (-15% / +10%).
The voltage drop due to the cable shall be taken into account. The
table at the right, shows the maximum distance between power
supply and 1 unique device, depending on cable gauge and power
supply rating.
RJ45
IDEMIA - 2018_2000035854
– V1
1-3
Power + 12V
Red
2-4
Power GND
Black
