MSO Fingerprint scanners Installation Guide
Error! Use the Home tab to apply Titre 1 to the text that you want to appear here.
2018_2000039830
October 2021
This document and the information therein are the property of IDEMIA. They must not be copied
or communicated to a third party without the prior authorization of IDEMIA
31
10.5 Usage
Those products are planned to be set on a table.
Do not open the products and modify the housing for a different usage.
10.6 Accessories
Use your MSO terminal with original accessories. Attempts to integrate the MSO terminal
with unapproved accessories will void your warranty.
10.7 Environment conditions
Do not use your MSO terminal in damp areas (ex: swimming pools etc). It must be
protected from water and other liquids.
Do not expose your MSO terminal to extreme temperatures.
Do not expose your terminal to direct sunlight.
Due to electrostatic discharge, and depending on the environment, synthetic carpet
should be avoided in areas where the MSO terminal has been installed.
10.8 Cleaning precautions
It is recommended to clean the sensor when it is dirty.
It is recommended to use a blowgun before rag in case users brought sand or hard
dust with their fingers. Use compressed gas for electronic devices to avoid
electrostatic discharges.
In order to eliminate organic marks, a weekly cleaning is required. In this case, using a rag
moistened with diluted dishwashing liquid is advised.
It is advised to clean the sensor after 1000 uses, with a lightly damp rag, to dry it and to
wait a few minutes before starting up again the terminal.
The cleaning material for sensor must be a soft material to prevent scratches:
Hard dust and sand can scratch products and can damage MSO xx1 OEM and
MSO301/351
To disinfect the terminal, moisten a non-abrasive wipe with the disinfectant Windex®
Multi-Surface (or similar product containing L-Lactic acid) and wipe the device’s surface and
leave the surface wet with disinfectant for at least 5 minutes.
