Maximum weight supported by the bar 60 kg
Warning:
• Make sure the handle is properly attached before use, check it, and replace it if necessary.
• THE PULL MUST REMAIN PERPENDICULAR TO THE HANDLE AS SHOWN IN THE PHOTO.
• Placing the handle on a surface that is too wet can cause it to slip and fall off.
• Check the good condition of each suction cup before installation: The suction cup must not show
any abnormal deformation (bulging, cracking, etc.).
• The suction cup must not show any abnormal deformation (bulge, cut, swelling). It must be flat,
smooth and slightly smooth and slightly flat.
• Before each use, check the adherence of the 2 suction cups by pulling slightly without leaning. If
one or both suction cups are not adhering to the wall, you must remove and reposition them. Check
the tightness of the suction cups every time you use them.
• The levers must be resistant when operated. If there is no resistance means that the suction cup is
not operational.
• The suction cup must protrude at least 1 mm all around the plastic part. If the suction cup does not
protrude (even very partially), it will easily come off = potential danger.
• Do not overestimate the hold of the product and use it sensibly.
• This system has the advantage of a quick installation but implies a quality installation on a quality
support.quality substrate.
• Remember to test the hold firmly before you actually stand on the product.
• This product is not intended for people with disabilities or physical problems. It should not be used
as a support ramp.
Delivered by :
Identités – ZA Pole 49
Bd de la Chanterie
49124 Saint Barthélémy d’ANJOU