Version Juin 2023
12
Use and precautions
: Before using for the first time, loosen the black screw located at the top of the vertical upright
⑤
, just
below the tray
①
. This screw is used to lock the upright jack. It should be retightened if the bed table is to be transported.
Adjust the height of the Corfou bed table to the correct height by pulling on the
vertical post adjustment lever while raising or lowering the tray, then release the
lever. Locking and unlocking the brakes on the castors
⑦
is done using the small
lever placed on each castor.
To tilt the large platter, slightly loosen the star knob 14, tilt the platter and then
tighten the star knob again.
Caution:
Check that the table is correctly assembled and tighten the screws regularly. Always use on a flat surface. Always keep
the brakes locked when the table is not in use. Do not overload the table.
823127 :
Etape 1
: Screw the wheels
④
and
⑦
under the U-shaped foot
③
using the open-end spanner.
Etape 2 :
Place the ① and ② trays (holes facing
up) on a flat surface.
Align the holes in the vertical upright plate ⑤
with the holes in the small plate ①. Prepare the screws ⑪ by threading in
first a split washer ⑬, then a flat washer ⑫on
each
screw. Screw the upright plate ⑤ onto the small plate ①.
Place the U-
plate ⑧ around the tube and screw it onto the
large plate ②. Place the tilt bracket ⑥ and screw it onto the
screw it onto the large plate ②. Screw and tighten the
large plate with the star knob
⑯
