Version Juin 2023
14
Use and precautions
: Before using for the first time, loosen the black screw located at the top of the vertical upright
⑤
, just
below the tray
①
. This screw is used to lock the upright jack. It should be retightened if the bed table is to be transported.
Adjust the height of the Corfou bed table to the correct height by pulling on the
vertical post adjustment lever while raising or lowering the tray, then release the
lever. Locking and unlocking the brakes on the castors
⑦
is done using the small
lever placed on each castor.
To tilt the large platter, slightly loosen the star knob 16, tilt the platter and then
tighten the star knob again.
Caution:
Check that the table is correctly assembled and tighten the screws regularly. Always use on a flat surface. Always keep
the brakes locked when the table is not in use. Do not overload the table.
SAFETY PRECAUTIONS
Failure to observe the precautions for use may result in the risk of serious injury.
- Use the bed table only as described in this manual.
- Do not exceed the maximum weight of 15 kg
- Install the bed table on a flat surface.
- Store the bed table indoors, away from mould and dust.
- Check that the adjustment knobs work properly before use.
- Before use, check that all parts are present and in good condition. In the event of damage, please contact your dealer.
- Carefully follow the assembly instructions and ensure that all components are correctly secured before use.
- Before use, apply the brakes to the castors.
- If any parts are damaged, broken or worn, please contact your dealer.
