Page 36
Picture 4.6 set the time section
【
Interval
】
Only one alarm signal is turned on even there are several motion detect signals in the set
interval.
【
Alarm output
】
Start the external equipment of corresponding linkage alarm when the motion detect
alarm is turned on.
【
Delay
】
Delay a few moments and stop when the alarm state is turned off. The range is 10~300
seconds.
【
Record channel
】
Choose the recording channel (multiple option supportive). Trigger the video
signal when the alarm is turned on.
Note:
Set in the [recording setup] and perform the linkage recording. Start detecting video files
in the corresponding time section.
【
Tour
】
■ means that the selective channel is single window alternate patrol preview. The interval is
set in the [MainMenu]>[System] > [Tour].
【
Snapshot
】
Choose record channels,when alarm happens,system triggers related channels for
snapshot signal.
Note
:For
Snapshot
activation,pls
go
to
set
period,detect
and
alarm
enable
at
MainMenu->Record->Record config,
【
PTZ Activation
】
Set the PTZ activation when the alarm is turned on.
Note:
PTZ activation is set in the [shortcut menu] >[ PTZ control]. Set the patrol between spots,
trail patrol and so on.
Summary of Contents for ICR-E42-83-163
Page 1: ...Page 1 Identivision ICR E42 83 163 Installer Manual EN ver 1 2...
Page 74: ...Page 74 Weight 3kg without hard disk Installation Desktop...
Page 79: ...Page 79 Appendix 8 FTP Setting 12 14 minutes long videos...
Page 80: ...Page 80 Service LDSZ Kft 1117 Budapest N dorliget u 7 b www identivision hu en...