R&D
Access Touch 2.0 – User Manual
Version 1.03
Public
4 (12)
Author: Hal
File: C00320E
Date:
18.8.2012
Approved:
Jpo
Printed:
20.08.2012
09:45
Idesco Oy | Teknologiantie 9, FIN-90590 OULU | Tel +358 20 743 4175 | info@idesco.fi | www.idesco.fi
5.
Installation
NOTE! Power must be turned off from your VDC feeding device when making connections!
5.1.
Installation, mechanics
Feed all necessary wires through the insert holes in the middle of the back cover (picture 1). Install
the back cover to the wall using the four mounting tracks show below (picture 1).
Picture 1: Note two cable egress ports provided in the middle of the back cover and the four mounting tracks
provided in the corners
5.2.
Installation, electronics
Connect all necessary wires to the Access Touch 2.0 PCB (e.g VDC, GND, Relay control…)
Follow diagram in picture 2 below for locating different connector hubs. Each connector’s functions
are described separately in the following chapters.
NOTE: It is highly recommended that you
deploy an independent power supply as a backup in the event of power interruptions.
