MT-50 Multitouch Table DIY Building Instructions–Version 1.2 - 4/5/11 - Page 11
bus, and cause something (usually the tracker) to go crazy, or the system to
give you a lovely blue screen error.
If you intend on using USB cameras such as the PS3Eye, then additional
1394 cards are not necessary.
The form factor of the computer is very small. We would recommend you
use the case we have listed (or something very similar) to place the system
in. The small form factor is needed to fit a high end system in the table
without taking up room that would affect the IR lighting and projected
image.
Computer Specifications
The MT50 standard computers have the following hardware:
Intel i7 930 2.8GHz processor
NVidia GeForce 470 Graphics Card
4GB DDR3-1600 RAM
2 300GB 10,000 RPM SATA hard disk drives in a RAID 1
configuration(using the system boards soft RAID system)
Windows 7 Professional
2 dual channel IEEE1394A cards
920 Watt Power Supply
Custom power switch set up
Many of these parts can be changed out. You will need the 920-Watt
power supply (this also powers the fans and IR lights) and the 1394 cards.
Using a lower amount of RAM and a slower processor may result in a
slightly sluggish computer.
Summary of Contents for MT-50
