MT-50 Multitouch Table DIY Building Instructions–Version 1.2 - 4/5/11 - Page 7
Installing the Bottom Panel
Once the frame is complete, you will want to install the bottom panel. The
bottom panel will have 6 120mm fan cutouts, and have cut-outs for 2
boxes; a power box for the incoming 120v power 2x4 handy box), and a
cut-out for the Input/Output/Power Switch box (2 gang metal box).
To attach the bottom panel to the frame, you will have to orient the panel
correctly on the frame. There is one side of the frame that uses Part C
(45x45mm strut with a notch cut out). That is the side that the projector
will be on. If you were standing on that side of the frame, the bottom panel
cut out for the smaller electrical box should be on the right side, the larger
electrical box cut out on the left side, both on the opposite of the side you
are standing on.
Place 14 M5 screws (not included with Bosch kit) and T-nuts into the
outside holes around the perimeter of the panel. Once all of the screws
and T-nuts are in, flip the entire Bosch frame upside down, and place the
panel on with the orientation described above. Line the T-nuts up so that
they all fall into the middle channel on the strut. Tighten up all of the
screws around the perimeter so that the bottom panel is snug and lined up
with the frame.
You can now attach the wheels that came with the kit, and should flip the
entire assembly on its side to install the fans.
Summary of Contents for MT-50
