6
Light Bar Color Codes
MODE
DESCRIPTION
Pairing Mode
The accessory is waiting for the handset to configure the accessory’s
Wi-Fi
®
. The LEDs
flash blue.
Pairing
The accessory is waiting for the handset to initiate and complete pair
set up through either Wi-Fi
®
or BLE (Bluetooth Low Energy).
The LEDs
are solid blue.
Pairing Expired
Pairing mode has expired and the accessory is waiting for the user to
press the button for about 3 seconds to reenter pairing mode.
The
LEDs slow flash blue.
Pairing Restart
To reinitiate the pairing mode, hold the button down for 3 seconds
and the LEDs will
rapidly flash blue.
Wi-Fi
®
Link Up
When the accessory joins a Wi-Fi
®
network, (i.e., the link is up) the
LEDs
rapidly flash green for a second.
Wi-Fi
®
Link Down
When the accessory has lost the connection to the Wi-Fi
®
network,
(i.e., the link is down) the LEDs
slow flash orange until the link is up.
Lockout
When the accessory has detected 100 failed pair set up attempts, it
enters lockout mode. The LEDs
slow flash red until the accessory is
factory reset.
Factory Reset
Hard Factory Reset
*Should be used as a last
resort. This will bring the
switch back to the original
firmware. It will need to be
updated after pairing
To initiate a soft factory reset, which will clear all WiFi and pairing
information, hold the button down for 10 seconds until the LEDs
rapidly flash red.
When the button is released the unit will reboot and
reenter the pairing mode.
To initiate a hard factory reset, which will clear all WiFi and pairing
information as well as revert the unit firmware back to the original
factory firmware, hold the button in while simultaneously plugging the
unit into the wall. Continue to hold the button until the LEDs
rapidly
flash red.
Release the button and the unit will reboot and reenter
pairing mode.
Identify
When the accessory receives a request to identify itself, it
rapidly
flashes purple.
Rating Information
UL Rated to UL STD 244A & STD 498A
Summary of Contents for SWITCH
Page 1: ...User Manual ...