12
STEP 5
Turn the power back ON at the breaker. Using your voltage detector,
identify which of the two wires you removed is energized. This is the
“line” wire. The wire that is not energized is the “load” wire.
Note these two wires for future reference.
NOTE:
Your home’s wiring may differ; please consult a qualified electrician.
Summary of Contents for Wall Switch
