36
STEP 2
Locate the Primary Switch. Hold “6” until the LED rapidly flashes
blue (3 seconds) then release. Next tap “1” to enter pairing mode.
The LED will slowly flash blue.
Next locate the Secondary Switch. Repeat the steps above on the
Secondary Switch by holding “6” until the LED rapidly flashes blue
(3 seconds) then release. Next tap “1” to begin the pairing mode.
The LED will flash blue slowly.
The Secondary Wall Switch will search and pair to the Primary
Switch. The LED on each Wall Switch will rapidly blink green 5
times and each Wall Switch will beep 5 times to indicate the pairing
process is complete.
Summary of Contents for Wall Switch
