17
During cutting, the gap between the blade tips (in the transverse direction) must not be
exceeded, otherwise the blade is in danger of breaking:
ATTENTION!
Where possible, avoid cutting through high-strength parts of the vehicle body
(e.g. side impact protection). This may result in damage to the blades or to
increased wear and tear!
eDRAULIC cutting device
max. gap at the blade tips
[mm]
/ [in.]
SC 258 E2
3
/ 0.12
SC 358 E2
3
/ 0.12
SC 757 E2
3
/ 0.12
SC 758 E2
3
/ 0.12
Cutting with
SC 358 E2
, SC 757 E2 and
SC 758 E2
The spreader tip of SC 358 E2, SC 757 E2 and SC 758 E2 can be removed. This prevents
the material from becoming stuck between the spreader tips, hindering the cutting process.
Removing the spreader tip
Step 1:
To remove the spreader tips, first push out bolt “A” a little, using a finger or an object. A fair
amount of force needs to be applied initially, as the bolt has a ball catch to prevent it from
falling out unintentionally.
3.
2.
1.
A
Summary of Contents for HURST eDRAULIC SC 258 E2
Page 43: ...43 14 Notes...
