2
5
Breathing bag
8
Charger
3
Air guide
6
Mouthpiece
7
Hand loop
4
Base module
2
Detachable module with
opening aid
1. BEFORE OPERATIONS
Before first use
1. Fully charge the battery.
2. Clean and disinfect the air guiding parts (air guide
3
, mouthpiece
6
and breat-
hing bag
5
) in accordance with the instructions in Chapter 5. On delivery, the air
guide
3
is placed inside the device. Open the device by pulling the opening aid
on the detachable module
2
.
Assembly
1. Place all parts on a table as illustrated below.
2. Insert the battery
1
into the detachable module
2
(see illustration on page 3).
3. Insert the air guide
3
into the base module
4
. Ensure the air guide is properly
inserted into the base module by pressing it into place.
4. Close the Idiag P100 by assembling the base module
4
with the inserted air
guide
3
and the detachable module
2
with the inserted battery
1
. To do this,
place the detachable module
2
at a 45-degree angle, flush to the base module
4
and bring the two halves of the grip together (see illustration on page 3). Once it
has been correctly assembled, the unit will beep.
5. Screw the breathing bag
5
at the bottom of the grip to the air guide
3
of the
Idiag P100.
6. Adjust the breathing bag
5
to match your breathing capacity (see table on page
11).
7. Push the mouthpiece
6
over the front end of the air guide
3
(see illustration on
page 3).
8. If required, clip the hand loops
7
to the silver pins on the front and rear of the
base module
4
.
1
Battery
