Part 3 - Search
65
Motion Search
Select
Motion Search
from the Search menu to bring up
the Motion Search Setup window.
Motion Search cannot be performed while using a split
screen layout. Select Single Screen mode.
Select
Option...
to configure Motion Search options.
•
Select
First
under
From
and
Last
under
To
to search
the recording from start to finish. Alternatively, you
can uncheck the
First
and
Last
options and specify the
search time frame manually.
•
Type
:
Motion Search
looks for motion in the selected
area by comparing individual frames against their
preceding frames. This means slow and gradual
movements, no matter how long they persist, will not
be recognized. In contrast,
Museum Search
looks for
changes in the specified area by using the
From
frame
as a reference. Museum Search, therefore, recognizes
even minute deviations from the original
From
frame.
•
The
Zone
setting can be configured in the identical
manner as the Zone setting under System Setup -
Motion Detection. For more information, refer to the
.
Museum Search
may not function properly if the
edge of the object is included in the
Zone
. For more
accurate search results, set the inside of the object's
edge as the detection zone.
•
Sensitivity
: Set to between 1 (Low) and 5 (High).
•
Min. Blocks
: The
Min. Blocks
option is available with
Motion Search only.
Once all the options have been configured, select
Search
. Select search results entry to display the video
recording on the left. To play the recording, exit the setup
window by selecting
Close
.
