Part 1 - Remote Setup
20
•
Switching Level:
Sets up the switching level between
daytime and nighttime modes. For example, if the
darkness level is set to
3
and th
e
brightness level to
5
, t
h
e system switches to nighttime mode when in
lighting conditions of level 3 or below and to daytime
mode when in lighting conditions of level 5 or over. It
is recommended that you do not set up the darkness
level and brightness level identically; otherwise, this
function may not work properly. This functions only
when
B&W Mode
o
r IR Cut Filter
is set to
Auto
.
Pan/Tilt Driver
Configure
Pan/Tilt Driver
settings.
•
Product/ID
: Specify the mounted pan/tilt driver’s
model and then set up an ID. Click
Port
and enter
the pan/tilt driver’s port speed, data bit, stop bit,
and parity values as per the driver manufacturer’s
instructions.
Pan/tilt driver cannot be controlled if it is not
properly connected to the RS485. For more
information on RS485 port connection, refer to the
RS485 Port
in the installation manual and the pan/
tilt driver manufacturer's manual.
